"junction-vertices" container

The junction-vertices container is a list of junction subcontainers with no standalone tags and is used by KIND FixedTrack assets. Each junction subcontainer uses the following format. Each junction derives its name from the subcontainer's tag name. These names are used to refer to specific junctions from script.

Junction subcontainer

Each junction subcontainer supports the following tags. Each tag is shown here with its default value.

junction-lever-mesh ""
junction-mutex ""
junction-mutex-sharing-forward 0
junction-mutex-sharing-left 0
junction-mutex-sharing-right 0
junction-vertex ""

junction-lever-mesh

Type: String

Desc: The "junction-lever-mesh" tag optionally specifies the name of a "mesh-table" Container entry to use for the junction lever. TBD: Animation? Multiple-state junction support?

junction-mutex

Type: String

Desc: The "junction-mutex" tag optionally specifies the name of a "mutexes" Container entry to use for the junction's mutex. This allows sharing a single mutex between multiple junctions, and requires a detailed understanding of the trainz Permit system. If ommitted, the junction will use a unqiue mutex.

junction-mutex-sharing-right

Type: Integer

Desc: The "junction-mutex-sharing-left", "junction-mutex-sharing-forward", and "junction-mutex-sharing-right" tags describe sharing masks for the junction's mutex. Two or more permits may be granted for a junction simultaneously if a bitwise and of their sharing masks gives a non-zero result. When a permit is requested by script for this junction's mutex, the appropriate sharing masks is selected based on the requested direction. If no direction is specified (eg. a legacy script is in use) then a sharing mask of zero is used.

junction-vertex

Type: Attachment point

Desc: The "junction-vertex" tag is compulsory and determines the track vertex at which this junction is to be created. This name must correspond to one of the vertices specified in the "attached-track" Container and the vertex specified should form a valid junction (ie. should have more than two track stretches attached.)

Junction-vertices Example

The following is an example of a simple "junction-vertices" Container which declares two named junctions.

junction-vertices
{
  one-junction
  {
    junction-vertex "a.track0a"
  }
  another-junction
  {
    junction-vertex "a.track2a"
  }
}