How to Control Junctions in Sessions
m |
m |
||
| Line 62: | Line 62: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
<table width="100%"> | <table width="100%"> | ||
<tr valign="top"> | <tr valign="top"> | ||
| Line 134: | Line 133: | ||
The following line is executed only if the junctions are set correctly | The following line is executed only if the junctions are set correctly | ||
*'''Line 4: Message Popup''' Displays a message window stating that the junctions are now correctly set. | *'''Line 4: Message Popup''' Displays a message window stating that the junctions are now correctly set. | ||
| − | |||
<table width="100%"> | <table width="100%"> | ||
<tr valign="top"> | <tr valign="top"> | ||
| Line 155: | Line 153: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | + | ---- | |
| + | This page was created by Trainz user '''<span class="plainlinks">[http://online.ts2009.com/mediaWiki/index.php/User:Pware pware]</span>''' in May 2018 and was last updated as shown below. | ||
| + | ---- | ||
[[Category:How-to guides]] | [[Category:How-to guides]] | ||
Revision as of 21:33, 4 March 2020
The information in this Wiki Page applies to TANE, TRS19 and Trainz Plus. It gives examples of how junctions can be controlled using Session Rules.
Contents |
 |
Junctions can be controlled by Session Rules during the running of a Session. |
The following applications give examples of using Session Rules to control junctions.
Application 1: Presetting Junctions
 |
The Scenario: |
When a consist reaches a trigger, the junctions ahead are set and configured (e.g. locked/unlocked, AI control allowed/disallowed).
 |
Rules Used: |
- Trigger Check Rule to trigger the event.
- Set Junctions Rule to set junctions.
 |
Session Editor Screenshot: |
 |
 |
Description: |
- Line 1: Trigger Check The event is triggered when the consist reaches a trigger. This executes the following rule.
- Line 2: Set Junctions Sets selected junctions to set directions and specifies the level of control by the users and AI.
For example:-
 |
 |
Application 2: Asking the User to Set Junctions
|
The Scenario: |
A consist has been halted at a trigger placed in front of a junction. The user will be asked to set that junction and the following junction before the consist can proceed.
 |
Preconditions: |
- Navigation Display Rule to create a navigation point set.
|
Rules Used: |
- Wait on Navigation Point Rule to trigger the event.
- Message Popup Rule to open a message window on the screen.
- Multiple Junction Alignment Check Rule to test if specified junctions are set correctly.
|
Session Editor Screenshot: |
 |
|
Description: |
- Line 1: Wait on Navigation Point The event is triggered when the consist halts at the navigation point assigned to the trigger. This executes the following rules simultaneously
- Line 2: Message Popup Displays a message window asking that the next two junctions be manually set.
- Line 3: Multiple Junction Alignment Check tests the switch directions of the next two junctions and waits until they are aligned as specified.
 |
| Checking junction switch settings |
The following line is executed only if the junctions are set correctly
- Line 4: Message Popup Displays a message window stating that the junctions are now correctly set.
|
Trainz Wiki
 |
More Tutorials and Guides to Using Trainz |
This page was created by Trainz user pware in May 2018 and was last updated as shown below.
