How to Control Junctions in Sessions
From TrainzOnline
(Difference between revisions)
m (→Related Trainz Wiki Links:) |
m (→Application 2: Asking the User to Set Junctions) |
||
| Line 37: | Line 37: | ||
'''2. Rules Used:''' | '''2. Rules Used:''' | ||
| − | *'''[[Session_Rule_List_with_Parameters# | + | *'''[[Session_Rule_List_with_Parameters#Wait_on_Navigation_Point_Rule|Wait on Navigation Point Rule]]''' to trigger the event. |
*'''[[Session_Rule_List_with_Parameters#Message_Popup_Rule|Message Popup Rule]]''' to open a message window on the screen. | *'''[[Session_Rule_List_with_Parameters#Message_Popup_Rule|Message Popup Rule]]''' to open a message window on the screen. | ||
*'''[[Session_Rule_List_with_Parameters#Multiple_Junction_Alignment_Check_Rule|Multiple Junction Alignment Check Rule]]''' to test if specified junctions are set correctly. | *'''[[Session_Rule_List_with_Parameters#Multiple_Junction_Alignment_Check_Rule|Multiple Junction Alignment Check Rule]]''' to test if specified junctions are set correctly. | ||
| Line 50: | Line 50: | ||
'''4. Example Explanation:''' | '''4. Example Explanation:''' | ||
| − | *'''Line 1: Wait on Navigation Point''' The event is triggered when the consist halts at the navigation point assigned to the trigger. This executes the following rules | + | *'''Line 1: Wait on Navigation Point''' The event is triggered when the consist halts at the navigation point assigned to the trigger. This executes the following rules simultaneously |
**'''Line 2: Message Popup''' Displays a message window asking that the next two junctions be manually set. | **'''Line 2: Message Popup''' Displays a message window asking that the next two junctions be manually set. | ||
**'''Line 3: Multiple Junction Alignment Check''' tests the switch directions of the next two junctions and waits until they are aligned as specified. | **'''Line 3: Multiple Junction Alignment Check''' tests the switch directions of the next two junctions and waits until they are aligned as specified. | ||
Revision as of 19:31, 16 May 2018
The screenshots shown below give examples of how junction settings can be used to control the operation of a session.
Application 1: Presetting Junctions
1. The Scenario:
When a consist reaches a trigger, the junctions ahead are set and locked into position.
2. Rules Used:
- Trigger Check Rule to trigger the event.
- Set Junctions Rule to set junctions.
3. Session Rules Screenshot:
 |
4. Example Explanation:
- Line 1: Trigger Check The event is triggered when the consist reaches a trigger. This executes the following rule.
- Line 2: Set Junctions Sets selected junctions to set directions and specifies the level of control by the users and AI.
 |
Application 2: Asking the User to Set Junctions
1. The Scenario:
A consist has been halted at a trigger placed in front of a junction. The user will be asked to set that junction and the following junction before the consist can proceed.
2. Rules Used:
- Wait on Navigation Point Rule to trigger the event.
- Message Popup Rule to open a message window on the screen.
- Multiple Junction Alignment Check Rule to test if specified junctions are set correctly.
3. Session Rules Screenshot:
 |
4. Example Explanation:
- Line 1: Wait on Navigation Point The event is triggered when the consist halts at the navigation point assigned to the trigger. This executes the following rules simultaneously
- Line 2: Message Popup Displays a message window asking that the next two junctions be manually set.
- Line 3: Multiple Junction Alignment Check tests the switch directions of the next two junctions and waits until they are aligned as specified.
 |
| Checking junction switch settings |
The following line is executed only if the junctions are set correctly
- Line 4: Message Popup Displays a message window stating that the junctions are now correctly set.
