View source for "Member-of-groups" container

The "member-of-groups" container is a top-level [[config.txt file]] entry which can be used by any [[Content_Configuration#Content_Types|content type]]. This container was introduced in [[trainz-build]] 3.5 and is not valid in older-version [[Config.txt file]]s.

The container holds a regular list of [[KIND Asset-group]] KUIDs. This asset will be considered as a member of each listed asset group.

If no entries are specified for a given "member-of-groups" container, or if the asset omits the "member-of-groups" container, then the simulator may specify some default asset groups based on the asset's [[Config.txt file]]. The exact behaviour may change between different versions of the simulator, however the current logic is described [[KIND Asset-group#Known Asset-Groups|here]].

The actual interpretation of what membership of a given asset-group means is documented [[KIND Asset-group#Interpretation|here]].


="member-of-groups" Example=
The following is an example of a simple member-of-groups container. This example declares the asset as a member of the 'Bridge Spline Group' and the 'Road Spline Group' (not necessarily a sensible combination.)

 member-of-groups
 {
  0 <kuid:30501:100046>
  1 <kuid:30501:100045>
 }


[[Category:Config Container|M]]